This is a genuine manufacturer sourced replacement part designed for use with jointer-planer. This part helps to secure knife inserts to the helical cutterhead. This part is made out of metal and it is sold individually. Requires a torx screwdriver to install or remove this screw.

This is an Genuine Manufacturer Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine OEM sourced replacement part used on Jet power equipment. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. This switch has a plastic body and it is sold individually.

To replace this switch you would need a Screwdriver.

• First make sure the tools is not plugged in
• Then you want to remove screws used to secure the switch
• Disconnect wires from the old switch and remove
• Secure the new switch and connect wires to it

The hex screw is an OEM direct from the Jet manufacturer. The metal item is made for use with several woodworking jointers. The hex screw assists with securing the lock knife bar. A wrench set is required for making the repair. The hex screw is sold individually.