International

This is an authentic KitchenAid part. This screw is used on many bowl lift style KitchenAid mixers to secure the Bowl Spring Latch (Part number 3182857) into place. This screw is a slot headed screws that is made of steel. You can rest assured ordering this screw knowing that it has been made specifically KitchenAid mixers. This screw will correctly fit and retain the Bowl Spring.

This is a genuine OEM part. The metal screw is compatible with a variety of Whirlpool appliances. It is recommended to purchase several screws, as they may need to be replaced over time and use. A Phillips screwdriver is often needed to make the necessary replacements. This part is sold individually.

This is an original part from the Whirlpool manufacturer. The idler shaft washer helps to secure the idler pulley wheel in many dryer machines. A screwdriver and a wrench are often helpful in making the repair. The metal, idler shaft washer is sold individually.

This is an original part from Whirlpool, Maytag, International, Jenn-Air, Crosley and Roper for use with Dryers. The support roller shaft attaches the support roller to the dryer and provides a place for the roller to rotate. The most common reason for replacing the roller shaft is if the bearing in roller went bad and gouged up the surface of the axle shaft. This part is sold individually. Here is a list of tools that are needed to replace the roller shaft are a Phillips screwdriver, 5/16” nut driver, snap ring pliers, flathead screwdriver, and 1/2” wrench. Unplug the dryer before installing this part.

This part is an OEM from Norge, Admiral, Magic Chef, Maytag, Crosley, Amana, Hoover, Jenn-Air, and International Washers. The snubber ring fits between the leg and washer base to reduce noise and vibration. The most common reasons for replacing the snubber ring is if the washer shakes a lot during use; loud noise during operation. This part is sold individually. Here is a list of tools that are needed to replace the snubber ring a short flathead screwdriver, flathead screwdriver, Phillips screwdriver, 1/4” nut driver, 5/16” nut driver, 3/8” nut driver, putty knife, locking pliers, slip joint pliers, ratchet with extension and a 3/8” socket.