Hotpoint
We sell only genuine Hotpoint ® parts.
Enter Your Model Number
Popular Categories
Same Day Shipping
Toll Free Support
Repair Help & Videos
Commonly Purchased Parts
See More +
Popular Parts
Rack Slide End Cap
Part Number: WD12X10304
In Stock, 25+ available
$7.85
This rack slide end cap is an authentic OEM component which is specially designed for use with GE dishwashers. It provides an identical replacement for a faulty or a missing item that was installed on a new unit. The end cap attaches to the rails for the upper rack to prevent it from sliding too far. Please refer to the appropriate diagrams of your model for the exact location and the correct installation of this part. Note, this high-quality end cap is made of durable white plastic and is sold as an individual component. Replacing it is a simple task that does not require any tools, simply press it on the rack slide rail.
Drum Slide
Part Number: WE1M1067
In Stock, 25+ available
$8.90
This is a genuine component that is supplied by the original equipment manufacturer for GE dryers. The green drum slides are used to support the weight of the drum. The most common reason for replacing the drum slides are when they begin to make noise due to being worn out. These are sold separately and it is recommended you purchase two to replace both at the same time.
Drum Bearing Slide
Part Number: WE1M504
In Stock
$11.79
This is a genuine OEM sourced replacement drum bearing slide designed for GE residential dryers. The dryer's drum slides help to support the front of the drum as it rotates. There are two (2) per dryer. They attach to the outer-most sides of the bearing. It is advised to replace both sides at the same time. This item is made out of white plastic and it is sold individually.
TOP BEARING
Part Number: WE03X27679
In Stock
$24.94
This is a genuine manufacturer-sourced part which is specially designed for use with GE Dryers. This part helps to make your dryer operate as quietly as possible. When replacing the drum bearing you should also replace the drum sides. Please note that the drum sides will need to be purchased separately. You will need a torx screwdriver, flat head screwdriver, phillips screwdriver, and pliers.
Tub Dampening Strap
Part Number: WH1X2727
In Stock, 25+ available
$11.55
This is a genuine manufacturer-sourced part which is specially designed for use with GE Washers. The Dampening strap supports the wash tub and reduces the wash tub vibration. The reason for replacing the damping strap is if there is excessive wobbling of the machine or the tub of the washer bangs around a lot and is very noisy. The washer has 4 straps and is recommend to replace all 4 at the same time. This part is sold individually. The tools needed to replace the strap damping are a putty knife, 5/16 nut driver and a ¼ nut driver.
