This is an OEM part sourced directly from the manufacturer. The fuel filter helps to take out all the impurities and debris that could be harmful to the carburetor. This filter is most commonly used in trimmers, shredders, blowers, edgers and chainsaws. The compatible models are listed below. This part is made out of metal and a felt type material. This fuel filter is sold individually. To install this filter you will slide it onto the fuel line, then use a screw diver to position the clamp firmly over the nipple.

The Fuel Tank Vent is connected to the Fuel Vent Tube.
The purpose of the vent tube is to allow air in to the fuel tank so that a vacuum is not created when the fuel is being fed through the fuel line.
Most of the time the Vent line is connected to a fuel line grommet that is installed on the fuel tank.
The fuel return line and the fuel line are also connected to the fuel line grommet.

The other way a fuel tank is vented in other engines is by use of a fuel cap with a air vent built into it.

This is a genuine Echo replacement part.
It is sold individually.

By pressing the bulb it will purge the air from the carburetor.
Then fuel will come up from the fuel tank through the fuel line then into the carburetor.
The excess fuel will be forced back into the tank through the fuel return line.

Over time the primer will lose its elasticity or crack and need to be replaced.

This is a genuine OEM replacement part, it is sold individually.
By pressing the bulb, fuel will come up from the fuel tank through the fuel line then into the carburetor.
Then the excess fuel will be forced back into the fuel tank through the fuel return line.

At some time the primer will lose its elasticity or crack and need to be replaced.

We have an article and video on How to Replace a Primer Bulb, in our Repair Center. That can be found on the front page of our site.

This is an OEM replacement part and is sold individually.
Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine.
It will ignite the air fuel mixture by the spark.
Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual.

Over time a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors.
It is better to replace a fouled spark plug, rather then trying to clean it.

This is a genuine OEM replacement part, it is sold individually.
The purpose of this filter is to keep dirt and other small particles from entering the carburetor and engine and causing internal engine damage.

Once this type of filter gets clogged or dirty it should be changed (Not Cleaned). This is to prevent restricted air flow and foreign matter from entering the engine. This is a double layer air filter.