Coffee Grinder Parts
Search By Model Number
This is a genuine Presto replacement part. This is a 2 wire cord, 29 inches long. It is used to provide power to many appliances made by Presto. This part connects to the male posts on the different appliances. This part can be difficult to push onto the post when new. This part needs to be replaced if there are any sparks in the connecter or the posts. Over time the contact will ware with unplugging and plugging into the appliance. When replacing this part its suggested to make sure the posts on the appliance are clean and not damaged.
This is a genuine DeLonghi OEM replacement O Ring that is used to seal the filter to the generator. Over time this part will begin to deteriorate and will need to be replaced as the part is made of silicone. If the O Ring for your coffee maker has snapped or become worn, replacing this part will help restore optimum performance to a variety of models.
Outside diameter: 43.6mm. Inside diameter: 35.2mm. Thickness: 4.2mm.
This is a genuine Delonghi replacement part, It is sold individually.
This O-Ring is used in a number of Delonghi products.
Its purpose is to create a seal to keep fluids from leaking from the appliance.
This is a genuine Cuisinart replacement part, sold in a pack of two.
The purpose of the Replacement Charcoal Filter is to remove chlorine, calcium and water impurities when brewing with your Cuisinart coffee maker.
It is advised to replace the filters after sixty days or after sixty uses.
This is a genuine Hamilton Beach replacement part. This part is used for brewing a single serving of coffee grounds, or the single serve K-Cup packs. Used with Hamilton Beach 2-Way FlexBrew Coffee Maker, model# 49983S. Part is made of plastic, and is installed by snapping into place.
Browse Coffee Grinder Parts
Coffee Grinder Repair Videos
Coffee Grinder Repair Articles
|Quick Fix: How to Replace the Mantles on a Coleman Lantern|
|Learn how to easily replace the worn out mantles on your Coleman lantern....||If your lantern is no longer holding pressure in the tank then it is likely that the pump has become worn and will need ...|