Genuine Classen replacement part, this item is sold individually.
The 100001 Nylon Washer is used primarily in the handle assemblies of the machines listed below.
It will usually be used in conjunction with a nut and lock washer.

Genuine Classen replacement part, this item is sold individually.
There are four of these seals used on the Classen Equipment shown below.
They are placed inside of the 4172017 Blade Arms to keep dust and debris out.
When installing these seals, make sure the spring side is facing away from the bearing.

This authentic replacement part is designed for use with Classen sod cutters. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Bearings experience constant wear from pressure, heat, vibration and friction. Because of this, many bearings need to be periodically replaced. This part is made out of metal and it is sold individually.

This is a Genuine Manufacturer Sourced replacement parts used on certain Classen Aerators. This Closed Spoon Tine is made out of Metal and is Sold Individually. Aeration can be an extremely vital element to a healthy lawn because it allows air and water to penetrate built-up grass or lawn thatch.

Genuine Classen replacement part, this item is sold individually.
This is the part that makes contact with the turf when using a Seeder or Turf Rake.
Over time this part will wear down and not properly do the job it was intended to do.
When replacing this part it is advised to inspect the remaining Blades for wear.

Genuine Classen replacement part, this item is sold individually.
The spacer is used on the Classen Turf Rakes & Turf Seeders shown below.
The spacers are placed on the Satelite Shaft in between the Blades to keep them the correct distance apart.
Theses spacers have a tendency to wear, it is advised to keep a few of the on hand for future use.