Spring 286425-00
Part Number: 286425-00
Ships within 1 business day
Product Information
Description:
| This part is available as an individual replacement. The spring attaches to the bushing and is made of metal. When replacing this item a set of pliers, a screwdriver, and an allen wrench may be needed. It will need to be replaced if it becomes broken or bent. This is an authentic DeWALT replacement part that is sourced from the original manufacturer for use with planers. |
Frequently Purchased With
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Planer
Questions & Answers for Spring
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
1 of 1 people found this instruction helpful
Tool Type:
Planer
Repair Difficulty:
Medium
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, Allen wrenches
Bushings on the feed rollers badly worn.
Disassembled the machine. Cleaned and lubed the roller shafts and the new bushings. Installed the bushings and the new springs. Cleaned and assembled the machine. Bushings appear to be a square cube. They are not. Make sure to put them in correctly. Other than that, the repair went smoothly.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Planer
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Snap ring pliers
Old rollers needed replacing
Took off old feed rollers and replaced with new + bushings, washers& springs
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Planer
Repair Difficulty:
Easy
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver
The infeed and outfeed rollers were worn from use
Removed the rollers and and springs from the unit after reviewing utube video. The repair is fairly straightforward and routine. One note the screws holding the rollers are extremely tight to prevent lossening during operation, they may even be loctited in place. I used an offset philips head to get better leverage in the small space. I destroyed one screw while removing (stripped out the head). They are M5-0.8 12mm long round head screws. To make replacements easier in the future I replaced the screws with torx head screws. They have the same profile just get a better grip with the torx bit than the phillips head. The parts supplied were perfect and the springs probably don't need replaced every time the rollers go bad, I tested the old and new springs with a compression tension gage and found only about 5-8% difference between the old and the new, maybe chane every other or every third time.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
