Quick Fix: How to Replace the Motor Mount Bracket on a DeWalt DW718 Miter Saw
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Replacing the motor mount bracket on a DeWalt DW718 saw is an easy repair that you can complete in about 25 minutes--including the time it will take to remove the armature. Check out our article on removing a DW718 armature if you need help with that aspect of the repair.
Remember to use our DeWalt parts finder to find the right motor mount bracket for your saw.
Replacing the Motor Mount Bracket
1. Loosen the belt tensioning screw
Back the belt tensioning screw away from the metal pad. You do not need to remove it completely.
2. Remove the motor mount screws
Remove the six screws that secure the bracket. Then remove the bracket from the saw.
3. Install the new motor mount bracket
Set the new bracket in place. Look for the marks the old screws left and make sure you put the screws back in the same location to ensure proper belt tension.
4. Tighten the belt tensioning screw
Tighten the belt tensioning screw back down until it comes into contact with the metal pad.
Conclusion
And that's how you can replace the motor mount bracket on your DeWalt miter saw. This simple repair will help keep your motor running smoothly with the support it was designed to have.
Remember to use our power tool parts finder to find parts for all your other power tools.