How to Replace the Blade Clamp on a DeWALT Chop Saw (Model 28715)
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Saw chopping into your budget? It's time to face the fix. Whether you are a commercial contractor or a weekend welder, eReplacementParts.com provides the parts, procedures and facts you need to fearlessly fix what fails you.
The blade clamp secures the blade (abrasive wheel) to the saw. This particular blade clamp is a tool-free design. It features a built-in clutch to ensure that the blade is always tightened to the proper torque. Stripped threads are the most common issue with the blade clamp. Failure of the clutch (tightening) mechanism is also common. If you discover that the threads are damaged on the blade clamp, you'll want to inspect the threads inside the arbor shaft for similar damage.
This article provides step-by-step instructions for removing and installing the blade clamp on a DeWALT chop saw (model D28715).
Let's talk chop.
REMOVING THE BLADE CLAMP [top]
1. Unplug the saw.
Disconnect power to the saw.
2. Remove the blade clamp.
Raise the blade guard.
Depress the wheel-lock lever and rotate the abrasive wheel until the lock lever engages the slot on the blade washer. (The wheel will lock in place when the lever engages.)
Loosen and remove the blade clamp.
INSTALLING THE NEW BLADE CLAMP [top]
3. Install the blade clamp.
Depress the wheel-lock lever and rotate the abrasive wheel until the lock lever engages the slot on the blade washer. (The wheel will lock in place when the lever engages.)
Thread the new blade clamp onto the spindle.
Tighten the new blade clamp until the knob clicks at least 3 times.
Do-it-yourself repairs like these are easier than you might think: From lawn machines to cordless drills, kitchen mixers to outdoor grills. Our "how-to" articles walk you through each repair from start to finish.
So, doing-it-yourself means never having to do it alone.
Find your next fix here.