This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This cord protector is a genuine Porter Cable replacement part and is sold individually.
Cord Protectors are designed to slide onto your cord and fit securely at the end, where it’s firm rubber will protect the base of the cord from getting bent and pinched.
Which can expose the wires and become a safety hazard.

This is a genuine Porter Cable replacement part, it is sold individually.
A Cord Strain Reliever is used on most all power tools.
It purpose is to reduce the bending of the cord as it comes out of the housing, which otherwise would cause the cord to crack and wear.

This is an Genuine OEM replacement part that is used on a variety of equipment. This part is sold individually. The main function of a ball bearing is to reduce friction and facilitate smooth rotation of an axis. This part is included with Gearcase Assembly Part Number: 605082-00SV.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life.
Power Cord Specifications:

Genuine Manufacturer Sourced replacement part designed for use with some Angle Grinders. This part is made out of Carbon with a Lead Wire attached. This item includes One (1) Carbon Brush per order.

Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.