This is a genuine OEM sourced replacement part designed for use with Penn reels. Rod clamp is mounted to the back side of the rod and it attaches to the bottom of the reel to give the reel extra stability. Please note the hardware to attach this clamp is sold separately. This item is made out of black plastic and it is sold individually.

This friction drag washer is a genuine OEM component which is made for use with Penn fishing reels. The purpose of this part is to provide a tight seal between components of the drag mechanism. If the fish pulls on the line hard enough, the reel will rotate backwards, letting the line out and preventing the line from breaking. Over time the friction drag washer will wear out and it may begin to fail eventually requiring a replacement. Check the diagram for your model to ensure the exact location and the correct application. You may need a screwdriver to take the reel apart when performing this repair.

This is a genuine OEM sourced replacement gear designed for use with reels. This is an important part of the reel mechanism. It is made out of metal and it is sold individually.

Replacing this gear you would need a screwdriver to remove the side plate.

Genuine Penn replacement part, this item is sold individually.
This Handle Assembly is used on the Penn Reels shown below.
The handle comes as a complete assembly
Simply thread the handle in and you're ready to cast away.

This is an OEM sourced replacement part designed for use with Penn reels. It covers the opening for changing your handle from left to right retrieve. Without this part internal components of your reel will be exposed to outside dust and debris, and, eventually will compromise its functionality. It is important to always keep that cover on. This dust cap is made out of plastic and it is sold individually. It has threads on the inside that will allow this part to be screwed on to the reel body, therefore no additional tools are required to attach this item.

Genuine Penn replacement part, this item is sold individually.
By setting the tension on the drag washer, it will either allow the drag on your reel to loosen up or you can tighten it.
This part does wear out often , it is advised to have a few extra on hand.