Tub Bearing WH2X1198

Unscrew handle halves. Remove screws holding handle to saw and remove. Unscrew wires to trigger and remove. Screw handle half to saw that holds trigger. Install trigger wires to new switch and install into handle. Tuck in the wires as not to get pinched and install second half of handle and screw together. Install screws to a fix handle t ... Read more o saw. Table or foot repair starts with removing depth adjustment screw by removing retaining clip then handle and increasing nut. Remove nut at front of saw at the table. Remove table. Position table onto saw body and screw front screw and nut. Position rear adjustment arch into threaded stud and replace nut. Adjust the nut so the Table can go up and down. Position the lever so down is tight and up loosens enough to adjust depth. Install keeper e clip. On old table remove adjustment nut and install on new table. Just reverse the process to install. Done. Now the saw will cut square and the honey dos will go easy.