Part Location Diagram of 83812 Ridgid Cover Motor
See part 30 in the diagram
( Grid squares measure 1x1 inch )

Cover Motor 83812

Manufactured by:
Ridgid
ERP Number:
ERP11869970
Part Number:
83812
Original Equipment Manufacturer ?
$44.51
Special Order

Easy 

30 - 60 mins 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Troubleshooting

This part works with the following brands:
  • Ridgid
This part works with the following products:
  • Utility Vacuum

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

30 - 60 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

The motor had burned out in my Ridgid shop vacuum after 12+ years of intense usage.

Dave from Tallahassee, Florida

5 of 5 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Parts Used:
83812, 83807
Use a phillips screw driver or power drill with phillips bit to remove all the motor cover screws. Once the cover is off, take a few minutes to examine the wiring inside the cover. The replacement motor has to attach to the power lead from the on/off switch and to the ground wire. It\'s pretty basic electrical circuitry. Unclip the leads from the old motor using needle-nose pliers. The leads have clips that slide off the metal tabs. Remove the old motor, then be sure to clean out the bottom cover [mine had sawdust residue and other grime]. Position the new motor in the same spot, put the motor screws back in and connect the electrical leads.

Before replacing the motor cover, make sure the on/off switch is seated property in the handle and that the incoming electrical cord is seated in its special notch on the base cover. Put the motor cover on and replace the screws, making sure to press the two halves of the cover together as you go (this is part of your dust protection). If the halves of the cover don\'t mate snugly, then take off the top cover and make sure there\'s nothing impeding the reassembly.

My replacement motor fired up instantly when I plugged it in and I am a happy camper. Thanks, eReplacementparts. Ya done good.

Dave H.
Did you find this story helpful?
Thank you for voting!
  • 1

Model Cross Reference

This part works with the following models:
ERP Number: ERP11869970
Manufacturer Part Number: 83812
Brand Model Number Description
Ridgid WD1660 Utility Vacuum - Wet/Dry Vacuum
Ridgid WD16650 Utility Vacuum - 16 Gallon Wet/Dry Vac
Ridgid WD1665M Utility Vacuum - Wet/Dry Vacuum