- This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
- New stock is on the way! On order parts usually ship within 7 business days.
- Item is not in stock and usually ships 10-15 business days from the time you place your order.
- This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
Auto On-off Pcb 120v - Xc W107406161
- Manufactured by:
- Makita
- ERP Number:
- ERP11886472
- Part Number:
- W107406161
Works with your model VC4710!
$258.45
In Stock
Delivers in 3-5 Business Days!
Works with your model VC4710!
Troubleshooting
This part works with the following brands:
- Makita
This part works with the following products:
- Utility Vacuum
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
- < Prev
- 1
- Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Switch/knob to activate the vacuum stopped working.
Michael from Grand Marais, Michigan
0 of 1 people
found this instruction helpful.
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
- Parts Used:
- W107406161
Pretty simple repair. Remove the top of the vacuum using two different size torx bits. Take photos or remove the wires and tubes one at a time and transfer them to the new board/switch. Knob is held on with a flat head set screw. Reassemble being careful to route wires so they arenGÇÖt pinched.
Did you find this story helpful?
Thank you for voting!
The timer switch was bad
Don from SMYRNA, Tennessee
0 of 1 people
found this instruction helpful.
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
- Parts Used:
- W107406161
Removed the outer cover. Removed mounting screws from the printed circuit board. Removed electrical wiring one wire at a time and installed that wire in the same location on the new printed circuit . Next move the 2 vacuum hoses from the board to the same locations on the new board. Install the new board and outer cover. Check operation o
... Read more
f vacuum.
Read less
Did you find this story helpful?
Thank you for voting!
Vacuum wouldn\'t start. I believe the switch was bad but you can\'t get just the switch. you have to replace the whole circuit board.
Michael from MILTON, Wisconsin
0 of 1 people
found this instruction helpful.
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
- Parts Used:
- W107406161
Remove the top cover of vac by removing a handful of torx screws to expose the motor and circuit board and then swap out the circuit board connections one by one.
Did you find this story helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP11886472
Manufacturer Part Number: W107406161
Manufacturer Part Number: W107406161
| Brand | Model Number | Description |
|---|---|---|
| Makita | VC4710 | Utility Vacuum - 12 Gallon Wet/Dry Vacuum |
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
✖