Part Location Diagram of W107406161 Makita Auto On-off Pcb 120v - Xc
See part A-8 in the diagram
( Grid squares measure 1x1 inch )

Auto On-off Pcb 120v - Xc W107406161

Manufactured by:
Makita
ERP Number:
ERP11886472
Part Number:
W107406161
Original Equipment Manufacturer ?
  Works with your model  VC4710!
$258.45
In Stock
Delivers in 3-5 Business Days!

Easy 

15 - 30 mins 

(3 rated repairs) ?
  Works with your model   VC4710!

Troubleshooting

This part works with the following brands:
  • Makita
This part works with the following products:
  • Utility Vacuum

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(3 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Switch/knob to activate the vacuum stopped working.

Michael from Grand Marais, Michigan

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Parts Used:
W107406161
Pretty simple repair. Remove the top of the vacuum using two different size torx bits. Take photos or remove the wires and tubes one at a time and transfer them to the new board/switch. Knob is held on with a flat head set screw. Reassemble being careful to route wires so they arenGÇÖt pinched.
Did you find this story helpful?
Thank you for voting!

The timer switch was bad

Don from SMYRNA, Tennessee

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers
Parts Used:
W107406161
Removed the outer cover. Removed mounting screws from the printed circuit board. Removed electrical wiring one wire at a time and installed that wire in the same location on the new printed circuit . Next move the 2 vacuum hoses from the board to the same locations on the new board. Install the new board and outer cover. Check operation o f vacuum.
Did you find this story helpful?
Thank you for voting!

Vacuum wouldn\'t start. I believe the switch was bad but you can\'t get just the switch. you have to replace the whole circuit board.

Michael from MILTON, Wisconsin

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Parts Used:
W107406161
Remove the top cover of vac by removing a handful of torx screws to expose the motor and circuit board and then swap out the circuit board connections one by one.
Did you find this story helpful?
Thank you for voting!
  • 1

Model Cross Reference

This part works with the following models:
ERP Number: ERP11886472
Manufacturer Part Number: W107406161
Brand Model Number Description
Makita VC4710 Utility Vacuum - 12 Gallon Wet/Dry Vacuum