Remove outer covers. Remove gas tank screws being careful not to lose the spacers remove 2 fuel lines ( note which line goes where }. I had ordered the gas tank and also the gas line and filter, but did not need the line and filter because the tank comes with the line installed, filter and cap. Install gas lines to original locations. R
... Read moreeinstall gas tank making sure spacers are between tank and motor The spark plug is only visible after removing the heat shield which is also under the cover, remove plug check gap on new plug .025 and install. Install all covers.
Filled with gas pumped bulb 4X set choke pulled 2X started and ran like new
It was time to perform a major tune-up on my 4-cycle trimmer. This included replacing the air filter and spark plug. Also, an oil change and gap check and inspection on the valve rockers.
The gas cap had leaked from the filtered-vent. Previous cleanings failed to correct this issue. the only remedy is to replace the fuel cap.
<
... Read morebr />eReplacementParts.com is the perfect place to find OEM replacement parts.
Thank you!
1. Replaced carburetor
2. Replaced carburetor gasket
3. Replaced spark plug
4. Unit would not run, was getting no gas. After blowing in the fuel tubes, the feeder tube was plugged.( Should have done this first )
5. Removed the fuel tank, found the restrictor/filter corroded and plugged. Disassembled the restrictor
... Read more, used safety wire to clear the passageway cleaned everything reassembled. Unit ran fine. ( There was no mention of this problem in the comments )
6. Adjusted the idle a little. Amazing!
7. The parts were not needed but, I left them on anyway.
Removed air filter housing, carburetor and fuel lines. I took the fuel tank off to clean dirt/debris off it. It was easier too, to replace fuel line and fuel return in tank. Carb, gasket, and spark plug were simply a take off and replace. Trimmer started on 3rd or 4th pull as the choke lever is hard to get used to. If you pump the pr
... Read moreimer like 8x, it will start cold. No carb adjustment needed. Apparently the O-ring on the oil dipstick was bad. I replaced both since cost was low.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
