This drive control cable is a high quality replacement part that is sourced from original equipment manufacturer for use on high wheeled trimmers. The control cable stops the blade when the control handle is released, if the cable is broken it will cause the brake to not release even when the lever is pressed. Please note one durable rubber insulated cable is included per order.
1. Removed bottom shield.
2. Removed belt idler assembly and drive belt.
3. Removed bad control cable.
4. Installed new control cable, tied to handle.
5. Reinstalled belt idler assembly and belt.
6. Reinstalled bottom shield.
1. Disconnect the old drive control cable from the trimmer head control bar.
2. Use a screwdriver to remove the plastic clip holding the drive control cable on the upper handle.
3. Use pliers to pinch plastic clip on drive control cable connected to the chassis.
4. Remove control cable from unit.
5. Follow 1-4 in r
... Read moreeverse to install new drive control cable.
6. Tilt the trimmer at a 45 degree angle so I could access below the chassis where the return spring and drive control connects to the idler assembly.
7. Connect the drive control spring to the idler assembly.
8. Remove damaged return spring (idler spring) from the idler assembly.
9. Install new idler spring to the idler assembly.
10. I had a missing chassis cover screw that I added as well.
11. I referred to online instruction manuals for reference.
12. Current V-belt was still good, ordered new one as backup.
1. Removed fuel tank and carb from tiller and cleaned out tank.
2. Installed tank and crab. Filled gas tank and ops checked carb (tiller was hard to start and had to pour a little gas down the carb). After initial start up, I let it run for 15 mins. After shutdown, I attempted an other start after 2 hours and the tiller started on
... Read more the first pull.
1. Removed carrier plate assembly and discovered a bearing had come apart. Purchased a new bearing at the auto parts store and installed. This operation required the use of a press to remove the gear.
2. Installed carrier plate
3. Removed and replaced drive cable and completed a successful operation check
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9286772
Manufacturer Part Number: 532181699
Lawn Mower
- Weed Eater Lawn Mower Model 96172000101 Parts
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
