Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Bosch 4900 Table Saw Speed Control and associated parts.
I ordered and received a Bosch 4900 table saw speed control board, various screws, brush kits and bearings. Speed Control identical to bad board, worked fine. It was a bit difficult tracking parts, as apparently some parts were delayed which delayed entire order. Exploded view helpful, but unclear when zoomed in. Even so, I felt 5 stars are in order!
Guest - December 24, 2021
Verified Purchase
★★★★★
★★★★★
GENUINE PART,WORKS AS EXPECTED.
LIKE I SAID ABOVE RIGHT PART WORKS AS EXPECTED.
Guest - April 6, 2022
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1, Removed end cap from motor
2. Remove outer plastic case.
3. Removed plastic blade housing cover.
4. Removed front metal gear assembly cover.
5. Removed Armature from gear housing.
6. Used bearing puller to remove front bearing
7 Used Large 1/2 drive socket to install new bearing
8 Removed & re
... Read moreplaced front rubber ring seal
9. Remove and replace rear bearing.
10. Cleaned gears and housing.
11. Repacked axle grease around gears, bearing and inside housing
12. Reassembled in the reverse order.
Note: The hardest part of this is reinstalling the two screws that hold the armature assembly to the front gear housing. There is a metal plate that the two screws that go through the housing into the metal plate on top of the armature. That plate is free-floating and there is about a 1/4\" of clearance between the housing and the plate and the top of the armature assembly. Gravity is your enemy trying to get the plate and the screw to line up because there is NO room to put a screwdriver tip or anything inside the space. I tried for over an hour to get one of the screws started again with no success. Finally I went to my screw bin and found a 2\" screw the same size and thread pattern as the original and use my scratch awl to line up one side of the plate to the hole. I use the long screw in the opposite side of the plate to temporarily screw it in and bring the plate to the top, where it was supposed to be, then removed the scratch awl, and put in one of the original screws and tightened it. Then I was able to remove the long screw and put the other original screw in the other side. After that was done I tightened both of the original screws and and rest took about 15 minutes. Maybe this will help someone else in doing this bearing replacement?
This repair was on a Bosch Model 4100 table saw, which by the way is a GREAT saw!
Rick
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP19514074
Manufacturer Part Number: 2610998571
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
