Seat-inlet 801317

Had 2 Toro snow blowers in the shop the same month with B&S engines, plastic carbs and same issue. A good thorough cleaning, new seat/needle and bowl gasket did the trick. Make sure ALL the small fuel/air holes are cleaned including main jet. Plenty of great You Tube videos on that. Potential problem if carb is over tightened when re- ... Read more installing could lead to throttle shaft binding. Move the throttle shaft & governor spring to make sure it doesn\'t bind every-so-often when tightening carb. If possible check for proper RPM before replacing bottom shroud. Specs vary a bit depending on your model.

Most important, always use fresh gas/oil mix; drain & run dry for summer storage. Start the new season with fresh gas/oil mix too. Difficulty of repair will vary. Take it slow.

Removed bottom bowl from carburetor, removed old needle and seat, installed new. New gasket an reassembled.
Remove bolts holding old scraper and installed new.

1. Pinched off fuel line and disconnected from carburator.
2. Removed carburator from engine (2 Phillips head screws) while disconnecting air link-vane from governor;
3. Drained carburator;
4. Removed bowl screws and bowl gasket;
5. Removed and replaced brass valve seat and valve needle;
6. Reassembled with n ... Read more ew nozzel screen and gaskets;
7. Reattached carburator while reattaching governor air link-vane;
8. Reattached fuel line and released fuel line pinch.