Whirlpool Mixer Hardware

This metallic retaining ring is less than an inch in diameter. It is made entirely of metal.

7-18 x 3/4-Inch - sold individually.

This small metal pin locks the center gear to its shaft inside a stand mixer. Replace it if the pin is bent, broken, or missing. A damaged pin may let the motor run while the beater stays still. This is an internal gear pin, not the large hinge pin that joins the mixer head to the base. Use the full mixer model number to guarantee the proper fit. Unplug the mixer before opening the gear housing.

This groove pin is a small but essential metal piece used in stand mixers to secure the internal gears and keep the planetary assembly firmly attached to the drive shaft. When this pin wears out or breaks, the beater may stop turning or feel loose during use. Replacing it restores proper mixing performance and keeps attachments running smoothly without wobbling. Installation requires basic tools a...

Used on Stand Mixers.

Use with stand mixers. Screws are not included. Cap only.

Used with Stand Mixers.

Used for Kitchenaid Stand Mixers.

This idler shaft retaining ring is well under an inch long and is made of metal.

This part is used with the stand mixers attachments, as well as to hold the end cap to the front of the mixer.