This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.
I bought a new base with the felt pad included and brushes years ago from here and the feet.
At the time I needed the base because it was bent and the feet were shot.
This time I decided to replace the brushes and clean the entire sander out , it is a BO4510. It was full of sanding dust . All I needed was a s
... Read morecrew driver .
I took the sander completely apart washed the 2 case half\'s in dish soap and brew them dry. I also brew all the sanding dust off the field and armature and cleaned the commutator because it was covered with carbon and cleaned the brush holders.
The bearings felt fine . Then I put it all back together , took photo\'s to know how it was so I could put it together as it should be.
I replaced the two rubber pins that keep the base bearing and lower bearing from spinning , they were flattened .
The only thing I would advise is when you install the base to the feet make sure the sandpaper clamps are even with the base edge , you will see if they are not . To do this loosen the 2 screws and take a small screw driver to move the feet which moves the paper clamps then tighten the screws then do the other side. If you don\'t the paper clamps will not hold the sandpaper well. I decided to look and noticed they were not lined up proper. You cannot simply slap the base on .
1. removed angle drive cap (4 phillips #2)
2. removed drive gear (pliers and 10 mm)
3. removed snap ring
4.removed bearing
5. clean away old grease with metal grindings.
6. new grease and reassemble.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10145018
Manufacturer Part Number: 263002-9
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
