Part Location Diagram of 802303 DeWALT CONNECTOR
See part 34 in the diagram
( Grid squares measure 1x1 inch )

CONNECTOR 802303

Manufactured by:
DeWALT
ERP Number:
ERP18986730
Part Number:
802303
Original Equipment Manufacturer ?
  Works with your model  PC1002!
$5.95
On Order

Easy 

30 - 60 mins 

(1 rated repair) ?
  Works with your model   PC1002!

Product Description

?

This item is a genuine Porter Cable replacement part that is intended to be used with routers, band saws, and sanders. The plastic connector is used when repairing portions of the switch or motor. The connector is used to link the ends of two wires. This item is available as an individual replacement part.

Troubleshooting

This part works with the following brands:
  • Porter Cable
This part works with the following products:
  • Sander Polisher
  • Router
Part# 802303 replaces these:
802303, P802303,

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

30 - 60 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

The cord, sleeve and pad needed replacement.

ROBERT from MANHASSET, New York

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Parts Used:
802303, 879182, 682063, 895035, 838270
I removed the top half of the housing, replaced the cord and sleeve. Then removed the old pad and cleaned the surface. I put a small piece of very thin metal duct tape over the bearing hole. Then I sprayed a light coat of 3M high tack adhesive on the pad and reinstalled it....Job done!!
Did you find this story helpful?
Thank you for voting!
  • 1