1. Open tool halves, multiple phillips screws.
2. Remove power and cam unit, hands.
3. Remove cam unit covers, 6 screws.
4. Remove c ring on cammed gear.
#The c ring may disintegrate, buy 2 of these just in case!
5. Remove the reciprocating unit by hand.
6. Remove the c ring from the end of the sh
... Read moreaft.
#The c ring may disintegrate, this is where the 2nd c ring you bought goes!
7. Slip the rear and front sliding bushing off, and the fiber sheet and clip plate off the shaft.
# Note that there is a small notch in each sliding bushing.
# They are opposed in placement, other than that they are the same.
# So order 2 front sliding bushings and use one as the rear bushing!
8. Clean everything.
9. Reassemble in reverse order. Add plenty of heavy duty grease to the sliding bushings and gears.
10. When putting the halves back together remember to open the saw seating latch and insert it through the opening in the left half of the saw, so you don\'t spend 20 minutes trying to figure out why the gun won\'t go back together!
11. There are notched guide slots for the trigger and motor wiring. Insure they are seated properly to avoid pinching and breaking when reassembling.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10083930
Manufacturer Part Number: 672353001
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
