This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 16 Gauge • 8 Feet Long
Troubleshooting
This part works with the following brands:
DeWALT
Porter Cable
Black and Decker
This part works with the following products:
Reciprocating Saw
Part# 330081-08 replaces these:
P330081-08,
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
5 stars
1
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Quality Service
Great service and quality products...
Guest - July 24, 2019
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Very simple. Remove torx screws and handle cover, make note of correct wire connections and remove old cord w/sm. screwdriver to release push lock connections. Remove cord protector off old cord and slide on new cord. Push in new wire connections making sure they go back to correct position. Reinstall handle cover.. Ready to go...
1) Removed blade as time to replace, set new throat plate into place and adjusted for slide height to table.
2) Removed electrical box (two screws) from under table saw
3) Disconnected quick connects.
4) Prepared new cord with female terminal connectors.
5) Plugged cord in, refit cord / box and tightened attach
... Read morement screws.
Read less
Did you find this story helpful?
Thank you for voting!
Cord was cracked in numerous places. For safety replaced entire power cord
Disassembled power switch. Removed old cord. Put new female spade connectors on new cord. Installed cord and fastened power switch together and tested saw.
Placed table saw on work bench on its side, easier access to switch housing. Removed torx head screws (4). Took a picture of the connections of the back of the switch. This was a reference for the way the cord plugged in to the back of the switch. Unplugged the old cord from switch. Then had to run to the hardware store to purchase new fe
... Read moremale16-14 insulated spade connectors. Crimped the new connectors on the new power cord. Routed the new cord through the table saw, same as the old one was. Reinstalled the switch housing to the table saw. Placed table saw on floor. Plugged it in and turned it on/ off.
=ƒæì=ƒæì
Sat table saw on its side. Removed cord from its holder. Unplugged female and male ends. Crimped New female ends onto New electrical cord. Plugged female and male ends together. Replaced cord holder.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
