This is a genuine OEM replacement part for Homelite and Ryobi pressure washers. The switch is used to turn the machine on and off. This is a complete switch which is located inside of the motor housing. This is made of plastic and metal components and is sold as an individual replacement part.
Popped the old switch out with a putty knife and a screwdriver. Pulled the connectors with pliers. Checked the sealing boot. Connected the wires to the new switch with pliers and snapped it back in place. Powered it up with a water connected properly and it worked great.
Found your website and ordered my part as listed on your schematic. Removed the plastic Cover and old switch and install the new one, easy peazy. An interesting thing to note is that the on off switch that I ordered was not available on the Ryobi site. They wouldn\'t sell it.
Follow ownerGÇÖs manual safety instructions.
1. Remove pressure wand hose
2. Loosen large nuts holding hose connector and pressure hose fittings. If soap is in reservoir, tighten cap or dump soap out.
3. Turn over washer and remove deep set mounting screws. Needs long shafted Philips head screwdriver
4. Flip washer
... Read more over, remove soap reservoir top and carefully remove plastic cover. The front lifts before back releases. If soap is in reservoir, put top back on.
5. Remove power switch housing screws and lift housing out carefully.
6. Note down how switch is wired. This is a double pole single throw switch, switching both hot side and neutral on/off. Keep orientation same when retiring. Remove slide on wire connectors with needle nose pliers carefully.
7. Remove bad switch from housing carefully as to not crack housing. A small flat blade screwdriver can release the ears holding switch in housing. A bit tricky but gently will release switch from housing.
8. Replacement switch was very slightly bigger by a few mils on each dimension and would not fit into housing. So I scored a line on both top and side and using Rotozip tool shaved a tiny bit to widen and lengthen hole out to scoring mark. I checked new replacement switch would fit snug and ears snap fit into proper place.
9. Assembly is in reverse. Make sure wire connectors to switch are slid on completely and oriented the same as removed.
I just removed the damaged switch and put the new one on.. great product, easy instAll and quick shipping.. great customer service.. would highly recommend
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10010313
Manufacturer Part Number: 760504007
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
