Part Location Diagram of 2.880-154.0 Karcher O-ring Kit
See part F-19 in the diagram
( Grid squares measure 1x1 inch )

O-ring Kit 2.880-154.0

Manufactured by:
Karcher
ERP Number:
ERP9917416
Part Number:
2.880-154.0
Original Equipment Manufacturer ?
  Works with your model  K367MDPLUS!
$6.16
Special Order
Minimum Quantity of 2 required

Easy 

15 - 30 mins 

(5 rated repairs) ?
  Works with your model   K367MDPLUS!

Product Description

?

These are authentic items that are supplied by the original equipment manufacturer for use with Karcher pressure washers. Generally, O-rings are utilized to provide a tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to fail eventually requiring a replacement. Keep in mind this high-quality kit includes three durable rubber O-rings. Check the diagrams for your model to ensure the correct repair procedure.

Troubleshooting

This part works with the following brands:
  • Karcher
This part works with the following products:
  • Pressure Washer

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(5 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

The pressure hose repeatedly fell off.

Harnek from Elk grove, California

4 of 4 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Parts Used:
2.880-154.0
Remove the hose then seat the washer and reattach the hose.
Did you find this story helpful?
Thank you for voting!

Leaking pump bad o-rings and seals

john from LEANDER, Texas

2 of 2 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers
Took pump apart replace all rubber pieces put together check for leaks and operation. Finneeto! Done
Did you find this story helpful?
Thank you for voting!

Power washer wand hose connection at machine began to leak.

Victor from MOKENA, Illinois

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Parts Used:
2.880-154.0
1. Purchased o-ring kit.
2. Placed new o-ring in shoulder groove of brass wand connector

3. Admired a job well done
Did you find this story helpful?
Thank you for voting!

Old gasket failed, causing a leak

Stu from West Nyack, New York

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Parts Used:
2.880-154.0
Removed old gasket, installed new one. no tools needed
Did you find this story helpful?
Thank you for voting!

Gasket was worn.

Andrew from PARKER, Colorado

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Parts Used:
2.880-154.0
Cleaned the pressure connection and snapped the new gasket on it.
Your website had the right schematic and that made it easy to get the right part.
Did you find this story helpful?
Thank you for voting!
  • 1