Tile Saw Wheels and Rollers

This is the metal roller for the shaft, it helps to secure it and allows it to rotate freely with minimal friction. For correct location and use of this item make sure to check appropriate diagrams of our equipment. This replacement roller is a high quality item that is supplied by original equipment manufacturer for use with Dewalt wet tile saws. Please note this durable metal item is sold individually.

This is an authentic replacement part sourced from original manufacturer. It is designed for use with Ryobi table saw. This is the hand wheel that allows you to adjust height/bevel of the table saw. It is made out of metal and it is sold individually. Please note the hand wheel cap/cover is sold separately. To complete this repair you would need a screwdriver and pliers.

It is a high-quality component which is designed for use with Ridgid tile saws. The part is supplied directly from the original equipment manufacturer. This is one of the special guide rollers that allow table assembly to move back and forth on the rails. Unfortunately, over time the part may wear out, get damaged or even lost eventually requiring a replacement to maintain a properly functioning e...

The support roller attaches to the lock nut and is made out of plastic. This item is available as an individual replacement part. It is an authentic OEM sourced item which is specially produced for use with Ridgid tile saws. A screwdriver may be necessary during the installation of this part. Over time this part may break and will need to be replaced.

This is a genuine Ridgid replacement part that has been sourced from the original manufacturer to be used with tile saws. The durable plastic wheel attaches to the water pan assembly. The wheel is used to provide traction to roll the wheel when transporting the water pan. This wheel is sold as an individual replacement part.

This is a genuine item that is supplied by the original equipment manufacturer for use with Ridgid tile saws. The roller helps It is a high-quality replacement for a worn or missing small roller that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this part is made of...

The roller attaches to the cart and is made of metal. This is an authentic OEM sourced item which is specially produced for use with DeWALT wet tile saws. It is and is priced individually even though three may be needed. When replacing this part a screwdriver might be required. This part may become broken and will need to be replaced.