Delta Shaper Wheels and Rollers

It is an authentic item which is supplied by the original equipment manufacturer for use with Delta stock feeder shapers. The roller helps to feed the workpiece through the equipment. It is a high-quality replacement for a damaged or a missing component that was installed on a new unit. Refer to the owners manual and the diagrams of your model for the correct installation of this roller. You will ...

The roller attaches to the cover with the washer and the cap screw. This part is an OEM from Delta for use in stock feeder shapers. It is made out of metal and hard rubber and will need to be replaced if it stops turning. An allen wrench will be needed to replace this wheel. Keep in mind that this part is available as an individual replacement even though multiple rollers may be needed.

This replacement rubber tire provides the traction a stock feeder needs to grip and move material steadily through the machine. Before installation, unplug the machine and remove the worn tire from the metal wheel hub, taking care not to damage the hub. Clean away any rubber residue, sawdust, and grease, then inspect the hub for damage. If needed, soak the new tire in hot—not boiling—water for thr...