Sander Polisher Seals and Gaskets
Popular Sander Polisher Seals and Gaskets Parts
- Manufacturer Part Number:
- 151553-00
Genuine OEM replacement part, this item is sold individually. The 151553-00 Dust Seal/Brake is a dual propose part. It is a Dust Seal to help prevent dust and debris from entering the motor assembly. It also acts as a Brake to keep the sanding pad at lower RPM so the sander will work properly. It is a good idea to replace this part when you are replacing the sanding pad.
- Manufacturer Part Number:
- 144974-00
This is a genuine DeWALT replacement part to be used in sanders. The dust seal fits in the platen. It prevents dust from entering the device. This item is available as an individual replacement part, and may require a screwdriver to install.
- Manufacturer Part Number:
- 56194-00
O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness.
There are many causes for O-ring failure. The most common among power tools are:
• The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the O-ring, or caus...
- Manufacturer Part Number:
- 34-40-1870
This is an authentic manufacturer-sourced replacement component that is specially designed for use with Milwaukee sanders. It helps to provide an air-tight seal between connected parts, please make sure to refer to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber and is sold individually.
- Manufacturer Part Number:
- 01464
This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sold individually. Replacing this item you would need a wrench...
- Manufacturer Part Number:
- 213047-7
This is an authentic manufacturer-sourced replacement part, it is specially designed for use with Makita finishing sanders. Two of these o-rings are used to provide a strong seal for the foot, for correct application make sure to check appropriate diagrams of your model. Over time the o-rings may begin to deteriorate and crack eventually requiring replacement. It is a high-quality part which is ma...
- Manufacturer Part Number:
- 700871-00
This is an original DeWALT replacement part. The O-ring is designed by the manufacturer for use in random orbit sanders. This part is made of flexible rubber, and is used to seal the connection between the clamshell set and the baffle. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.
- Manufacturer Part Number:
- 34-40-4300
Included in part number 14-30-0302
- Manufacturer Part Number:
- 801852
This is an authentic manufacturer sourced replacement seal that is commonly utilized on electric power tools. It has multiple uses depending on the equipment, for correct location and use of this hardware please make sure to check appropriate diagrams of your tool. Over time these seals tend to shrink, become brittle and crack eventually requiring replacement. Please note this durable rubber seal ...
- Manufacturer Part Number:
- 339012430