Router Springs and Shock Absorbers

This eccentric spring is sourced directly from the original equipment manufacturer for DeWALT routers. It is an important part which applies tension on the safety cover. If the spring is damaged or is missing, this will provide an identical replacement. To ensure the correct installation of this hardware, check the appropriate diagram of your specific model. This high-quality spring is made of a d...

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.

This is a genuine Porter Cable and Black & Decker replacement part to be used with routers. The spring is made of durable metal. The part attaches to the inside of the depth adjustment ring and aids in keeping it in place. To complete the repair a Phillips head screwdriver is required. This item is sold individually.

The compression spring connects to the pin. It is made of metal and is sold individually. This is an OEM part sourced directly from the manufacturer and used in Makita saws. A set of pliers might be necessary during the installation of this item. This part will need to be replaced if it breaks or bends.

This is an authentic OEM part. The Makita compression spring 7 is made for use with several router and grinder devices. The metal spring is often fitted in the motor bracket, providing tension to the pin. This component is sold individually. Please refer to the specific manual for repair instructions. No tools should be necessary for making the installation.

This is a genuine replacement part sourced from the original manufacturer for use with routers. The metal spring is commonly used to provide compression between the knob and the carrier assembly. This spring is available as an individual replacement part, please note that tools are not required to complete this repair.

This spring-governor is an OEM part which is designed for DeWALT and Black and Decker equipment. It applies tension on the wing screw. Over time it may wear out and stretch eventually requiring a replacement. It is made of a high-quality metal and is sold as an individual component. Refer to the appropriate diagrams for your model for the exact location and the correct application of this hardware...