Pressure Washer Switches

This item is sold individually and is made out of plastic, rubber, and metal. The pressure switch connects to the pump and helps to control the pressure inside the tank. A set of pliers and a screwdriver might be required during the replacement of this part. It will need to be replaced if it becomes broken or frayed. This is an original part for pressure washers made by Homelite and Ryobi.

This is a genuine OEM replacement part for Homelite and Ryobi pressure washers. The switch is used to turn the machine on and off. This is a complete switch which is located inside of the motor housing. This is made of plastic and metal components and is sold as an individual replacement part.

This authentic OEM sourced replacement part is specially designed for Mi-T-M industrial hot water heaters. The switch is utilized to stop the heater once the high-temperature limit has been reached. Make sure to check the owner's manual and the appropriate diagrams for your model to ensure the correct repair procedure. This part is made from high-quality materials and is sold as an individual item.

This authentic OEM sourced replacement part that is designed for use with Karcher pressure washers. The purpose of this switch is to control on/off function of the unit. Because switches use mechanical internals, over time they will begin to deteriorate and fail eventually requiring replacement. This durable plastic switch is sold individually.

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation process, a wrench set and wire stripping pliers might be needed...

This part is an OEM from Briggs & Stratton. The switch and key is compatible with many small engines. This ignition component is sold individually, and includes a washer, nut, decal and key set. Please refer to specific manual and diagrams for making the repair. A screwdriver, pair of pliers and a wrench set are often necessary for the installation.

This pressure switch is an OEM direct from Mi-T-M. Compatible with many pressure washer models, this item is sold individually. Secured to the engine, this metal, wiring and plastic item allows the operator to (de)activate the pressure washer. For the replacement, you may need a wrench, screwdriver and needle-nose pliers. Please refer to the manual and diagrams for further repair instructions.