Power Feeder Parts

We sell only genuine OEM parts.

Popular Power Feeder Brands

See All

Powermatic Power Feeder Parts

Popular Power Feeder Parts

Control Switch

$115.84

Manufacturer Part Number:: 6289003

90a-4 Handle Assy M12 X 1.75

$51.87

Manufacturer Part Number:: 6289179

Rollers Set Of 4 Only

$239.51

Manufacturer Part Number:: 6289118

This is an original Powermatic replacement part. The rollers are designed by the manufacturer for use in power feeders. This is a complete set of four rollers made of metal and plastic, and they are attached to the base of the machine to allow it to move easily. You may require an Allen wrench or hex key when replacing this item. This product is sold individually.

Roller

$64.75

Manufacturer Part Number:: 1340360

The roller attaches to the cover with the washer and the cap screw. This part is an OEM from Delta for use in stock feeder shapers. It is made out of metal and hard rubber and will need to be replaced if it stops turning. An allen wrench will be needed to replace this wheel. Keep in mind that this part is available as an individual replacement even though multiple rollers may be needed.

Roller Bearing (3 Pack)

$72.73

Manufacturer Part Number:: 67997

It is a genuine replacement roller bearing that is supplied directly from the original equipment manufacturer for use with Ridgid drain cleaning machines. The bearings allow components to rotate with minimum friction, please make sure to refer to the appropriate diagrams of your model for the correct location and application of these parts. Over time parts will wear out and may begin to fail event...

Tire

$58.86

Manufacturer Part Number:: A12102

Tube

$72.47

Manufacturer Part Number:: 6288938A

Ball Bearing

$59.00

Manufacturer Part Number:: BB-6006ZZ

This is a genuine replacement part that has been sourced from the original manufacturer to be used with table saws, panel saws, spindle sanders, and air hoists from Powermatic and Jet. The metal ball bearing is used to limit friction between a rotating shaft and a fixed part assembly. The ball bearing is sold as a single replacement part.

Locking Handle

$39.57

Manufacturer Part Number:: 6288887

This is an OEM part sourced directly from the manufacturer. The locking handle is found on Powermatic feeders. This part is made of high-quality plastic, with an attached metal bolt, and is used to lock the motor clamp in place. No tools are required when replacing this item. Simply remove the old part and thread the new one into place. This part is sold individually.

Rollers-(set Of 3 Only)

$197.63

Manufacturer Part Number:: 6289116

This is sold as a set of three rollers. The rollers attach to the case covers. During the installation process, an allen wrench might be needed to replace these parts. They may become broken or worn down and will need to be replaced. These items are OEM replacement parts for use in Powermatic speed powerfeeders.