Porter Cable Nailer Caps and Lids

This is a Genuine OEM sourced replacement part designed for use with Staplers/Nailers. With this Exhaust Cover you can divert the air in any direction you want. It is made out of Plastic and it is Sold Individually. Please note Flange Nut used to secure the Cover is Sold Separately. To replace this item you would need a Hex Key/Allen Wrench.

This is a high-quality component which is designed for use with Porter Cable nailers and staplers. It is supplied from the original equipment manufacturer. The housing cap is secured in the back of a nailer to ensure a tight seal between the cylinder and the piston. If the cap is damaged or is missing, this part will provide an identical replacement. Make sure to check the diagrams for your specif...

This is an authentic replacement part manufactured for use with Porter Cable brad nailers and staplers. The special housing cap is the end cap that fits on the rear of the body and the cap includes the exhaust deflector. The special housing cap is available as an individual replacement part, please note the mounting hardware is available separately.

This is an authentic Bostitch replacement part that has been sourced from the original manufacturer to be used with pneumatic finishing nailers. The safety cover is used to cover and prevent damage to the driver guide assembly. This item is available as an individual replacement part.

This item has been OEM sourced to ensure a high level of quality. This deflector is intended to be used with pneumatic nailers from Bostitch. This part is used to cover the end or top of the cylinder and is used to deflect the exhaust air. This item is sold as an individual replacement part.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with pneumatic nailers. The cover connects to the exhaust deflector and is used to secure the cover. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

This cap is an authentic OEM replacement part sourced directly from the manufacturer. It is commonly used in Porter Cable nailers. This cap attaches to the underside of the trigger valve assembly. It is made of plastic and sold individually. It should be replaced if it damaged, missing, or will not tighten securely.