Makita Nailer Seals and Gaskets

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling - O-ring has ragged, tattered edges. These are commonly ...

This is an original Makita replacement part manufactured for use with demolition hammers and pneumatic nailers. O-rings are typically used to form a seal between two assemblies or prevent damage from parts that are in contact. Worn out o-rings can effect the tools performance, and replacing worn o-rings is part of normal tool maintenance. This o-ring is sold individually, please see model diagram ...

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Makita air compressors. It is utilized to provides a tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item. Over time the material will wear out and may begin to crack eventually requiring a replacem...

The o-ring goes on the driver and is made of rubber. This part is available individually. This item is an OEM from Makita for use in nailers. An allen wrench might be helpful during the installation of this part. It will require replacing if it becomes broken.

This o-ring is a genuine Makita replacement part, not imitation or overstock. O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure. The most common among power tools are: • Extrusion and Nibbling - The O-ring has ragged...

This is an authentic replacement part manufactured for use with Makita air compressors. The special gasket is used to from a seal at the connection between the valve seat plate and the top of the cylinder head. It is recommended to replace gaskets when servicing the compressor to ensure proper seals when the parts are reassembled. This valve seat to head gasket is available as an individual replacement part.

It is an authentic manufacturer-sourced replacement part that is specially designed for use with Makita nailers. This carburetor intake gasket which provides an air tight seal between connected parts, unfortunately, over time gaskets tend to deteriorate and crack eventually requiring a replacement. It is a high-quality component which is made of durable composite material and is sold individually.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with air compressors. The gasket kit is used to seal and provide spacing between the cylinder head, inlet/exhaust valve seats, the cylinder, and the crankcase. This gasket kit is sold complete with all four gaskets.