Hammer Seals and Gaskets

This is an authentic replacement part that is supplied directly from original equipment manufacturer for use with Chicago Pneumatic nailers. It is one of the o-rings for the throttle valve. Over time seals and o-rings tend to wear out and deteriorate eventually requiring replacement. Please note this durable high quality rubber o-ring is sold individually.

This o-ring is an authentic manufacturer sourced replacement part, it is not an aftermarket imitation. It is specially made for Chicago Pneumatic air hammers and sanders. It helps to provide an air tight seal between connected parts. Please make sure to check appropriate diagrams for correct location and use of this item. It is made from durable rubber and it is sold individually.

This replacement o-ring is specially designed for use with Makita rotary hammers. It is an authentic manufacturer sourced item that is used to provide a seal for the striker and the piston. For correct location please make sure to check appropriate diagrams of your unit. Over time seals and o-rings tend to shrink, become brittle and crack eventually requiring replacement. Please note one durable r...

This o-ring 21 is an OEM part direct from Makita. The flexible plastic ring is made for use with pneumatic nailers and rotary hammer tools. This item is often fitted between the compression spring and the driver, providing protection from friction. The o-ring 21 is sold individually. You will need a hex key for the repair.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling O-ring has ragged, tattered edges. These are commonly caused by p...

This is a genuine OEM sourced replacement o-ring which is utilized on Makita power tools. This component provides an air-tight seal between connected parts, over time the material may become brittle and crack eventually requiring a replacement to ensure the proper seal. It is a high-quality component which is made of durable rubber and it is sold individually.

This is an authentic manufacturer-sourced replacement o-ring which is specially designed for use with Makita scrapers. It helps to provide an air-tight seal for the impact bolt, over time it may wear out and crack eventually requiring a replacement. This is made of high-quality rubber material and it is sold individually.