Hammer Caps and Lids

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This is a genuine part which is supplied by the original equipment manufacturer for use with DeWALT and Black and Decker rotary hammers. The cap provides cushioning for the chuck. If the component is worn, damaged or missing, this will provide an identical replacement for the original cap that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the exact locatio...

This dust cover is an original part from the Makita manufacturer. The plastic dust cover is made for use with the HK1810 Scraper. This feature fastens the tool retainer to the barrel cover. The dust cover is sold individually, and a wrench is required for the installation.

This item is an authentic Makita part that has been sourced from the original manufacturer and is intended to be used with demolition hammers. The plastic dust cover is used to house and protect the switch to prevent debris from potentially damaging the switch. This item is available as an individual replacement part.

This is an original Makita part. The holder cap is made of plastic and is used in saws and hammers. It attaches to the carbon brush and holds it in place. This cap is sold individually, however a screwdriver may be needed to replace this item if it becomes cracked or broken.

This is an OEM part direct from the original manufacturer. The Makita cord guard 8 is made of durable rubber, and is compatible with various power tools. This item is often fastened into the housing and over the power cord, providing protection to the cord. The cord guard 8 is sold individually. A hex key and a screwdriver are helpful for the removal and repair. Please refer to the specific manual...

It is a genuine manufacturer-sourced which is specially designed for Makita power tools. Power cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point, right where the cord enters the tool. Unfortunately, over time the material will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made ...

It is an authentic Makita item that is supplied by the original manufacturer for rotary hammers. The cap prevents dust from falling over the tool and a user when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. Unfortunately, over time the material will wear out and it may begin to ...