Electric Drill Spindles

The spindle is the central component which drives the bit holder. Unfortunately, over time it may wear out or it can get damaged eventually requiring a replacement. It is supplied from the original equipment manufacturer for Black and Decker and DeWALT drills. To ensure the correct repair procedure, refer to the diagrams for your specific model. Note, it is made of durable metal and is sold as an ...

This is an original part from the Milwaukee manufacturer. The reversing spindle is composed of high-quality metal, and is compatible with several drill devices. This item drives the drill's bevel gear. It is often secured within the rev female coupling and ball bearing. This spindle is sold as an individual replacement part. A wrench and a screwdriver are helpful in making the repair.

This is an authentic Milwaukee replacement part manufactured for use with right angle drivers. The reversing spindle is the top spindle that drives the bevel gear. This spindle is sold as an individual replacement part.

This is a genuine manufacturer-sourced component which is specially made for DeWALT and Black and Decker drills. The spindle is an important part which helps to drive the drill bit. It is an identical replacement for a missing or a faulty spindle that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this it...

Service change : This spindle has been changed because of a tendency to crack or break. The threaded section has been reinforced with more metal. Because of this change, there is no longer a threaded hole to accommodate a chuck screw. When installing this new spindle, simply thread the chuck on normally. Regular use will ensure a tight, secure fit without a screw present.

This is an authentic manufacturer-sourced component which is specially made for use with Milwaukee equipment. It provides an identical replacement for a missing or a faulty part that was installed on a new unit. This is the spindle that drives the chuck. Please make sure to check the owners manual and the appropriate diagrams of your model for the correct location and application of this part. Kee...

This is an authentic Milwaukee replacement that has been sourced from the original manufacturer to be used with drills. The metal spindle is used to connect the spindle gear and the chuck to allow the parts to rotate in unison. This item is available as an individual replacement part, please see illustrated diagram for associative parts.