Demolition Hammer Caps and Lids

This cord guard / strain reliever is a genuine Makita replacement part. It covers the final portion of cord before entering the tool, providing extra rigidness and preventing cord damage. Over time these cord guards break down and require replacement. The guard is constructed of heavy duty rubber compound for toughness. This cord guard is compatible with the tools listed below. It is not guara...

This is an authentic Milwaukee replacement part manufactured for use with rotary hammers. The special dust cap is used to prevent debris from entering the sleeve. This dust cap is available as an individual replacement part, please see model diagram for associative parts.

This is a Genuine OEM replacement part used on Milwaukee Power Tools. This item is made out of Plastic and it is Sold Individually. The purpose of the Brush Cap is to retain the Brushes in the Brush Holders. This Brush Cap has external threads that thread into the housing of the tool. Be careful when removing and replacing these, they have a tendency to break. Order 2 to make a set.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This is a manufacturer sourced replacement part designed for use with Makita power tools. It helps to secure the brush in the housing. This screw-in cap is made of hard plastic and it is sold individually and measures 7-18 HM 1500. To replace it you would need a flat-head screwdriver.

This item is an authentic Makita part that has been sourced from the original manufacturer and is intended to be used with demolition hammers. The plastic dust cover is used to house and protect the switch to prevent debris from potentially damaging the switch. This item is available as an individual replacement part.

This brush holder cap is a genuine manufacturer sourced replacement part, it is not an aftermarket imitation. It is specially made for Makita power tools. It helps to secure the brush in the brush holder. This cap is made from durable hard plastic and it is sold individually. To replace it you will need a flat-head screwdriver.

This is a genuine OEM part. The tool holder cap is constructed of durable plastic, and is made for several demolition hammers. The protective tool holder cap is fitted onto the end of the chuck cover. This component is sold individually, and no tools should be required for the installation.

It is a genuine manufacturer-sourced which is specially designed for Makita power tools. Power cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point, right where the cord enters the tool. Unfortunately, over time the material will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made ...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with breaker hammers. The durable rubber guard fits over the power cord and is used to prevent excessive damage to the cord where it enters the housing assembly. This item is available as an individual replacement part.