Compressor Wheels and Rollers

This item has been sourced from the original manufacturer to be used with pressure washers and air compressors from Porter Cable, DeWalt, DeVilbiss, Black & Decker, and Delta. The air-filled wheel attaches to the axle or frame and is used to easily move the machine. This item is sold as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The wheel is commonly found in Campbell Hausfeld air compressors. This part is made of high-quality plastic and rubber, and is placed on the sides of the tank to make the machine easier to relocate. You will require a wrench when replacing this item. The wheel is provided as an individual replacement part.

This is a genuine manufacturer-supplied part that is made for Makita air compressors. It is one of the special wheels that support the equipment allowing for easy transportation. Over time it can get damaged or lost eventually requiring a replacement. This high-quality metal wheel is sold individually. Refer to the parts diagrams for your model to ensure the correct repair procedure. Note, the har...

This wheel is a genuine replacement part supplied by Mi-T-M. It is compatible with over 150 models of pressure washers. This wheel allows the operator to maneuver the machine easily by pushing it. This part is made of plastic and rubber. It should be replaced if it is worn or the tire is punctured. It is sold individually.

This is a genuine Porter Cable replacement part. The pneumatic wheel is commonly found on compressors and generators. This part is made of a rubber tire and metal hub, and is used to help move the machine. You may require a wrench when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with air compressors made by Powermate and Husky. The flywheel attaches to the oil seal and the carrier. When replacing this part a socket set and a wrench set might be required during the installation process. It is made out of metal and will need to be replaced if it breaks. This item is sold individually.

This is an original part sourced directly from Rolair which was designed for use with the electric air compressor listed below. This is one of the wheels that support the equipment and allow for easy transportation. Tools will be required to remove and replace this bolt that attaches this component to the machine. This item is sold individually.

This is an original Rolair replacement part. The wheel is designed by the manufacturer for use in a hand carry compressor. This part is made of high-quality plastic and rubber, and is used to allow the machine to move easily. This product is sold individually. Please keep in mind that the retaining ring used to secure the wheel may not be reusable, and may need to be replaced every time it is ...