Compressor Hoses and Tubes

This outlet tube is an OEM direct from Husky. The aluminum tube is made for use with the C801H, 80 Gal. Stationary Air Compressor. The tube discharges air from the pump to the air compressor tank. A wrench set and thread tape are helpful with the replacement. The outlet tube is sold individually. Please refer to manual and diagrams for safety and repair instructions.

This Genuine Manufacturer Approved replacement part is used on select Air Compressors. This tube is made out of Metal and it is Sold Individually. Please note Nuts and Fittings are Sold Separately. The outlet tube transfers air between the cylinder and the tank on an air compressor. The aluminum tube also helps to cool the air as it leaves the cylinder. After years of use under continual vibration...

This is a genuine replacement part sourced from the original manufacturer for use with air compressors made by Craftsman. This part attaches the pressure switch and manifold. This part is made of metal and durable rubber. This tube is sold individually.

This is a genuine manufacturer approved replacement part designed for use with air compressors. This is the hose that delivers air from the tank. It is made out of rubber and it is sold individually. Please note the hose clamps are sold separately.

This is manufacturer approved replacement part designed for use with air compressors. This is the hose that delivers fuel from the tank to the engine. It is made out of rubber and it is sold individually. Please note fuel filter and hose clamp are sold separately.

This is a genuine OEM replacement part, it is sold individually. It attaches to the inflators shown below. It can be used to inflate tires, balls, inner tubes etc. It does not include the hose clamp.

It is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT and Bostitch air compressors. This is an identical replacement for a missing or damaged outlet tube that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality...

Genuine Campbell Hausfeld replacement part, this item is sold individually. The ST033001AV Compression Nut is used to attach the copper tubing to certain components of the compressors listed below. Along with the Compression Nut you will need to use a compression sleeve ( or Ferrule) to seal the tube from leaking air. The Compression Nut will go on the tubing first then the Ferrule will slide into the nut.

This metal air compressor exhaust tube is used in compressors. It is used to vent gases away from the engine. Keep in mind this part is priced individually. It goes between the hose clamp and the tube seal and is an original manufacturer part. If it becomes broken a screwdriver and pliers may be needed during replacement.