Compressor Belts

it is a genuine item that is supplied directly from the original equipment manufacturer for use with Craftsman air compressors. This high-quality belt provides an identical replacement for a missing or damaged component that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item. Keep in mind...

This is an OEM part sourced directly from the manufacturer. The belt is commonly found in Craftsman air compressors. This part is made of flexible rubber, and is used to transfer power between the piston and the pump assembly. Over time, it may become cracked and brittle, requiring replacement. You may need an Allen wrench or hex key when replacing this part. This item is sold individually.

This is a genuine OEM approved replacement drive belt. It is supplied by original equipment manufacturer for use with Campbell Hausfeld air compressors. This is the belt that connects the pump and the electric motor. Over time these rubber belts tend to wear out and stretch eventually requiring replacement to maintain peak performance. Always make sure to clean the pulleys before installing the ne...

This is an authentic OEM sourced item that is specially designed for use with Craftsman air compressors. It is an identical replacement for a missing or worn belt that drives the unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality item is made of durable rubber and is sold individually.

This replacement belt is an authentic OEM sourced item, not an aftermarket imitation. It is commonly used on Campbell Hausfeld air compressors. It is the main belt that drives the unit. Over time rubber belts tend to wear out and stretch requiring replacement. Please note, this item is sold individually. To complete this repair you will need a wrench. • Remove the belt cover • Take out the o...

This is an original Rolair replacement part manufactured for use with air compressors. The special belt is used to link the motor pulley and the flywheel in order to drive the pump. This belt is available as an individual replacement part, please see model diagram for associative parts.

Genuine Bostitch replacement part, this item is sold individually. The purpose of this Belt is to run the compressor, to build up air in the compressor tank. It is attached to the crankshaft and to the shaft of the motor. This is a serpentine belt, meaning it has ridges on the inside of the belt to match up with the parts that drive it. It measures 3/8" wide and approximately 15" in circumference.

Squealing, slipping, or slow pressure buildup may be caused by a worn compressor belt. Worn pulleys or poor belt tension can cause the same problems, so check them too. This rubber V-belt is commonly listed under trade size 4L-530. Use the full compressor model and serial number to guarantee the proper fit. The new belt may be a different size than the removed belt because old belts stretch over t...