Circular Saw Hoses and Tubes

This is a manufacturer sourced replacement part used on a Milwaukee power tools. This part holds carbon brushes around the armature to provide stable and safe contact. Please note brushes are sold separately. This part is made out of plastic and metal. It is sold individually. To replace this assembly you would need a screwdriver and pliers. • First remove screws holding the cover together • ...

This is an Authentic OEM sourced replacement part designed for use with Husqvarna Chainsaws. This is the Hose that delivers fuel from the Tank to the Engine. It is made out of Rubber and it is Sold Individually. Please note Fuel Filter is Sold Separately.

This is a genuine Husqvarna replacement part that has been sourced from the original manufacturer to be used with power cutter saws. The metal nipple attaches to the water hose connectors. This item is used to create a water spray that lubricates the saw's blade. The nipple is sold as an individual replacement part, please note two nipples may be needed.

This is a genuine Husqvarna replacement part for use in power cutters. The hose goes between the housing and the spring. A set of pliers may be needed during the replacement of this part. It is made out of rubber and will need to be replaced if it breaks or leaks. This item is sold individually.

This is an authentic Husqvarna replacement part. The nipple is commonly found in Husqvarna chainsaws and power cutters. This part is made of high-quality plastic, and comes with an O-ring pre-installed at one end. It allows water to flow through the wet cutting system to prevent excessive dust and flying debris while cutting.

This item has been sourced from the original manufacturer to be used with power cutter saws from Husqvarna. The hose attaches to the blade case. This item is used to control the flow of water to the blade to keep it lubricated when cutting through masonry. This hose kit is priced as a single item.

It is an authentic OEM sourced item which is specially produced for use with Makita saws. The pipe attaches to the motor housing and is made of metal. A wrench and a set of pliers might be necessary during the installation of this part. It may become broken and will need to be replaced. This is available as an individual replacement part.