Milwaukee Chop Saw Bearings

This is an authentic Milwaukee replacement part manufactured for use with panel saws. The end bearing is used to guide material through the lower faceplates when making long rip cuts. This end bearing is sold as an individual replacement part.

It is a genuine OEM sourced item that is designed for use with Milwaukee power tools. This special bearing allows spindle shaft to rotate freely with minimal friction, over time the rollers of the bearing may begin to wear out and fail eventually requiring replacement. It is a high-quality component which is made of durable steel and it is sold individually.

This is an OEM part sourced directly from the manufacturer. The cam bearing is found in Milwaukee panel saws. This part is made of metal, and is attached to the face plate and extension rollers. You may require a wrench when replacing this item. The cam bearing is available as an individual replacement part.

This is an original replacement part sourced directly from the manufacturer. The bearing is found in abrasive cut-off machines from Milwaukee. This part is made of metal, and is used to allow the armature to spin freely. You may require a screwdriver or Allen wrench when replacing this product. This item is sold as an individual replacement part.

This authentic replacement part is specially designed for use with Milwaukee abrasive cut-off machines. The bearings are used to reduce the friction between connected rotating parts, the rollers take the load distributing the weight while the minimal contact area of the ball reduces the friction. Over time the material may wear out and begin to fail eventually requiring a replacement, please note ...

This is an original replacement part sourced directly from the manufacturer. The bearing assembly is found in Milwaukee panel saws. This is a complete set of four bolt clamps with bearings, along with washers, nuts, and plastic plugs. These are attached to the saw base to allow it to move easily up and down on the guide tube. You will require a wrench when replacing these parts.

This authentic replacement part is designed for use with Milwaukee equipment. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Keep in min...

This is an OEM Milwaukee replacement part for cutoff machines. The ball bearing is used to fit on the end of the armature and allow it to spin freely. The bearing is made of high-quality lubricated metal. The bearing is sold individually.