Echo Chop Saw Caps and Lids

This spark plug boot is an authentic OEM supplied replacement part, not an aftermarket equivalent. This rubber cap helps is used to connect the spark plug to the armature-magneto. Over time rubber material can dry out and crack requiring replacement. Please note, this part is sold individually.

Genuine OEM replacement part, this item is sold individually. The Vent Cover is installed on the vent tube on the carburetors for the outdoor products listed below. After the Vent Hood is installed on the vent line, the the Fuel Tank vent is attached to the Vent Hood.

This is an authentic OEM sourced part that is intended to be used with chainsaws and pruners from Echo and Shindaiwa. The plastic cap connector is used as a tether that keeps the fuel tank or oil tank cap connected to its respective tank. This item does not require tools to install and is sold as an individual replacement part.

The plug attaches to the bolt and the cushion. This item is made out of plastic and is priced individually. A wrench may be needed during the replacement of this part. It will require replacing if it becomes broken. This authentic item is supplied directly from the original equipment manufacturer for use with chainsaws made by Shindaiwa.

The cushion goes next to the screw and the collar. It is an OEM part sourced directly from the manufacturer and used in saws made by Echo. This item is available as an individual replacement part and is made of metal. An allen wrench may be necessary during the installation of this part. This part may become broken and will need to be replaced.