Band Saw Belts

This is a Genuine Milwaukee part It is sold individually Two tires are needed on the Bandsaw. If one tire is worn, it is advisable to replace both at the same time. The purpose of the Blade Pulley Tire is to keep the blade tracking correctly. Over time they will become brittle or stretched out. You then will have the problem of the blade coming off the pulleys or not tracking properly. The ti...

This matched set includes two V-belts that move power from the motor to the band saw wheels. Both belts are 1/2 inch wide. One is 41 inches long, and the other is 59 inches long. The different sizes are needed for the saws drive system. Use the complete saw model, type, and serial number to guarantee the proper fit. New belts may look smaller than the old belts because used belts stretch over time...

This is an authentic Delta replacement part. The drive belt is designed by the manufacturer for use in a band saw. This part is made of flexible rubber, and is used in conjunction with the pulleys to transfer power from the motor to the machine. This item is supplied as an individual replacement part.

This genuine Delta wheel tire is designed for use with a band saw. This is a belt designed for cutting wood. Please note drive belt used for cutting metal is sold separately. When putting the tire on a band saw wheel, it may seem too small but it is not. Band saw tires will typically come approximately 2 or more inches smaller than the tire you're replacing. The old tire stretches over time thus b...

The v-belt goes around the pulley. This is a genuine replacement part sourced from the original manufacturer for use with band saws made by Porter Cable. This item is sold individually and is made of a durable material. If this part becomes stretched or broken it will need to be replaced and may require an allen wrench during the installation.

This replacement belt is specially manufactured for use on Delta power tools. It is a genuine item that is sourced directly from original equipment manufacturer. It is commonly used as the main drive belt on band/table saws and drill presses. This belt is made out of rubber material and it is sold individually. You would need a screwdriver to complete a repair. • Remove the belt cover • Repl...

This is an authentic Delta replacement belt. It is sourced directly from original equipment manufacturer for use with band saws. It is connected to the motor pulley on one end and the wheel pulley that drives the blade. Over time belts tend to stretch and wear out eventually requiring replacement. Includes one (1) rubber belt. You will need a screwdriver and snap ring pliers to complete this repa...