Angle Grinder Springs and Shock Absorbers
Popular Angle Grinder Springs and Shock Absorbers Parts
- Manufacturer Part Number:
- 233376-2
This is a genuine Makita replacement part, it is sold individually. The 233376-2 Spring is part of the spindle lock system on the Grinders shown below. The reason for locking the spindle is so that you can remove and replace grinding wheels. The other parts need for the spindle lock system are part numbers. • 417771-6 Pin cap • 256486-8 Shoulder Pin • And 256486-8 O Ring.
- Manufacturer Part Number:
- N263579
The spring fits between the lock button and the o-ring. This part is an OEM from DeWALT for use in angle grinders. Keep in mind this high-quality part is made of metal and sold individually. A screwdriver might be needed during the installation process. Over time this part may stretch or break and will need to be replaced.
- Manufacturer Part Number:
- N291619
The spring attaches to the guard lever release. This part is an OEM from DeWALT for use in angle grinders. This item is available as an individual replacement part. It may require an allen wrench and a set of pliers during installation. It is made of metal and will need to be replaced if it becomes broken.
- Manufacturer Part Number:
- 40-50-1330
This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with angle grinders. The metal spring fits into the gearcase and is used to provide compression for the spindle lock button. This item allows the button to be pressed and keeps it in the upright position when not pressed. The compression spring is available as an individual replacement part.
- Manufacturer Part Number:
- 40-50-0386
- Manufacturer Part Number:
- 1604652015
- Manufacturer Part Number:
- 01468
This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.
- Manufacturer Part Number:
- 654197-3
This authentic part is supplied by the original equipment manufacturer and is specially designed for use with Makita angle grinders. It is an identical replacement for a faulty or a missing ring terminal that was installed on a new unit. Unfortunately, over time it will wear out and it may begin to stretch eventually requiring a replacement. This high-quality component is made of durable metal and...
- Manufacturer Part Number:
- 14-46-0241
- Manufacturer Part Number:
- 672592001
This item is a genuine Ridgid replacement part that is intended to be used with angle grinders. The metal spring is a direct replacement of the original spring that was installed onto the grinder when new. This part is used to keep the handle lock button upright in the lock position and to allow the button to be compressed when rotating the handle to a different position. The spring is priced as a single item.