Angle Grinder Hoses and Tubes

This item has been sourced from the original manufacturer to be used with angle grinders from Milwaukee. The durable plastic tube fits into the grinder's gearbox assembly. The spindle lock tube is used to secure the spring and the spindle lock shaft. The tube is sold as an individual replacement part.

This authentic frothing tube is sourced directly from the original manufacturer and is designed for use with the milk reservoir of espresso machines. Controlled by the frothing tube lever (sold separately), it plays a key role in dispensing frothed milk. Keeping the frothing tube clean is essential—if it becomes blocked, milk flow will be restricted or stopped entirely. This high-quality part is s...

It is an authentic manufacturer-sourced part which is specially designed for Dotco pneumatic grinders. The intake hose supplies air that powers the tool. Over time the material may wear out and begin to crack eventually requiring a replacement. Note, this high-quality part is made of durable rubber with two metal fittings and is sold as an individual component. To ensure the proper replacement pro...

This is an authentic manufacturer-approved component which is specially designed for use with Chicago Pneumatic pencil grinders. It is the hose that delivers the air to the tool. Unfortunately, over time it may wear out, get damaged or lost eventually requiring a replacement. Keep in mind this high-quality part is made of durable rubber and is sold individually. Please make sure to check the owner...

This genuine item is supplied by the original equipment manufacturer for use with Dotco grinders. It may require an adjustable wrench during installation. The overhose is made out of a durable material and will need to be replaced if it breaks. This item is sold individually.

This is an authentic Dotco replacement part manufactured for use with pneumatic grinders. This inlet hose carries the compressed air that powers the grinder. The inlet hose is available as an individual replacement part.

It is a high-quality item that is supplied by original equipment manufacturer for use with Dotco and Cleco power tools. This is the replacement collet chuck cap, for correct application make sure to refer to appropriate diagrams of your model. It is made of durable metal and it is sold individually, please note the retaining ring and other components are all sold separately.

This is an authentic Cleco replacement part. The grease fitting is found on a variety of power tools from Cleco and Dotco, such as clutches and sanders. This is a metal part that is fitted to the housing to allow lubricant to be fed into bearings or gears using a grease gun. This part is sold individually.