DeWALT Angle Grinder Brackets and Flanges

This is an Original Manufacturer Sourced replacement part used on Dewalt Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Hex Hole Flange Nut is to hold the Grinding Wheel to the Spindle Shaft. You would need Hex Wrench to secure this part.

This is a genuine Dewalt replacement part, it is sold individually. The 633257-00SV is used in conjunction with the 636226-00 Nut, to secure grinding wheels and cut-off wheels for the models shown below. It has a 5/8" bore.

This is a Genuine replacement part used on some Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Inner Flange is to hold the Grinding Wheel to the Spindle Shaft.

This is a genuine replacement bracket assembly. It is supplied directly from original equipment manufacturer for use with bench grinders. This bracket helps to secure the eyeshield to the main unit. It is made out of metal and it is sold individually. Please note the hardware and the eyeshield are both sold separately. To complete this repair you would need a screwdriver and a wrench. • Make s...

This item has been sourced from the original manufacturer and is intended to be used with bench top grinders from Black & Decker and DeWalt. The metal bracket attaches to the top of the left wheel guard and is used to mount the left side eye shield. The bracket can be purchased as a single item, please note the hardware and eye shield are separate items.

The flange fits between the clamp nut and the guard assembly. This part is an OEM from DeWALT and Black & Decker for use in angle grinders. This high-quality item is made of metal and is sold individually. It might become broken and will need to be replaced and a screwdriver may be needed during the replacement of this part.

This outer flange is specially produced for use with Black and Decker and Dewalt angle grinders. It is a genuine part that is supplied directly from original equipment manufacturer. This item is used to secure the grinding disk to the unit. Includes one (1) metal flange per order. Please note, a spanner wrench that is sold separately is used to tighten and loosen this part.

This is a genuine OEM replacement outer nut used on grinders. This part secures the grinding disk to the unit. A spanner wrench (sold separately) is used to tighten and loosen this part. It is made out of metal and it is sold individually.

This is an authentic part from DeWALT and Black & Decker for use in angle grinders. The outer flange attaches to the flange and is made of metal. When replacing this part the wrench will be needed. It will require replacing if it becomes broken. This part is available as an individual replacement part but also includes the wrench.

This item has been OEM sourced to ensure a high level of quality. The metal bracket is intended to be used with bench top grinders. The item attaches to the motor cover assembly. The bracket is used to mount the right side wheel guard. This item is sold as an individual replacement part.