1. Attached spring to retainer
2. Put spring and retainer into spring knob
3. Placed assembly into retainer
4. Replaced 3 screws
5. Adjusted tension
6. Inserted guard post into assembly
Removed jointer knife head assembly.
Pressed old bearings from assembly carefully marking right and left bearing mounts before removal.
Pressed new bearings into assembly.
Mounted assembly back into jointer base.
Checked alinement and bold torques.
Made final jointer table alinement adjustments and started j
... Read moreointer.
Read less
Did you find this story helpful?
Thank you for voting!
A part had broken under the strain of the shield spring
I removed three screws which held the assembly in place and together.
Reviewed the manual to insure the parts had been assembled correctly. I purchased the tool used only recently. The jointer shield is many years old and could have been incorrectly replaced some time before I acquired the tool.
I Reassembled the parts, lubri
... Read morecated the shaft and screwed them back into place.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_4.gif "Part Location Diagram of JT9-JH-T27 Jet RETAINER")
_WW_4.gif "Part Location Diagram of JT9-JH-T27 Jet RETAINER")
