ON-OFF SWITCH 2607200260

Remove the handle half
Make a wiring diagram
Disconnect the wires from the old switch
Connect the wires to the new switch
Replace the handle half

Unplug machine, look inside to assess problem. Mine showed melting of the trigger switch/power wire connection. Note location of all wires before disassembling. remove four wires and inspect...the melted one may need to be cleaned up. While machine is open, it\'s a good time to blow out all dust/clean with compressed air. Insert splices o ... Read more n two incoming power wires and reattach all four wires in original locations. Reassemble in reverse order.

Remove old pad by taking out one bolt. remove old friction ring (note orientation and just pull it off ) install new ring and sanding pad in reverse order.

Test your repair and have fun ! I have a sander that\'s good as new.

Opened sander up to access switch, replaced switch Great sander and a inexpensive made it good as new...

1. Removed cover from sander.
2. Popped out the old on-off switch.
3. Removed wires from old on-off switch.
4. Attached same wires to new on-off switch.
5. Secured 2 wire with screws from old switch.
6. Replaced cover and it works again.

1. Remove all screws securing the two halves of the housing
2. Seperate housing.
3. Use Air hose to clean housing and motor of dust, use a small brush to loosen any hard dust.
4. Loosen screws holding the feed conductors, armature, and field conductors.
5. Remove old switch and place new switch in recesses, attach ... Read more conductors and reassemble housing, insert screws and tighten.
6. Test run, then put the sander to use.